61
selection), limit the level of position accuracy to less than
what the receiver can actually achieve in this case.
Typically you will choose
RTK Position
to match with the
selected operating mode.
• Select the model of dynamics that suits the movement
pattern of your rover best.
• Click
Configure
.
• Set the device used by the receiver to acquire the two or
three sets of corrections:
–
If corrections are received via radio, go to
Receiver
>
Radio
to enter all radio parameters. You may use the
internal radio or an external radio.
–
If corrections are received over the Internet, go to
Receiver
>
Network
to set the device used (this may be
Ethernet, Modem or WiFi; more information about how
to set up theses devices can be found in the relevant
context-sensitive Help). Then go to
Receiver
>
I/Os
to
start data reception in NTRIP or Direct IP mode.
Trimble RTX Rover
Using a Trimble RTX service in the SP90m requires that you
first buy a subscription to this service. On the other hand, the
receiver is ready to operate in Trimble RTX mode (dedicated
firmware option has been pre-installed at the factory)
provided an L-band capable GNSS antenna is used.
On the receiver’s General Status screen, the receiver will
display “RTX” when computing a position using a Trimble
RTX service. The computed position is displayed after
pressing .
1
X-Y-Z or
Lat-Lon-Height
Position
Trimble RTX service
via IP or satellite
