36
If it’s OFF, use the following field to define an IP address
for the receiver.
•
Static Address
: IP address assigned to the receiver when
DHCP is off. This is a static IP address (up to 12 figures
in the form xxx.xxx.xxx.xxx).
To enter a new IP address, press
OK
then use the vertical
arrow keys to set each digit, and the right-arrow key to
move to the next digit.
Display Settings
This screen looks like this:
Pressing the down-arrow button will allow you to set the
following parameters, one after the other:
1.
Language
: Choose the user interface language (several
western languages available).
2.
Unit
: Choose the distance unit (
Meters
,
US Survey Feet
,
International Feet
).
3.
Screen Orientation
: Choose the orientation of the data
displayed on the screen (
Normal
or
Upside down
).
4.
Screen timeout
: Choose the time in minutes during which
the screen will stay lit after you leave the control panel
inactive. It will go blank after this delay. You will then
need to press any front panel button to turn it back on.
Enter “0000” to keep the screen permanently on.
5.
Buzzer
: Allows you to silence the buzzer if required. The
buzzer is on by default.
Advanced Settings
This screen looks like this:
Pressing the down-arrow button will allow you to set the
following parameters, one after the other:
1.
ATL Recording
: Is OFF by default. ATL data are used for
advanced diagnosis. You don’t normally have to record
ATL data unless you are requested to do so by Technical
Support.
