11
installed driver does not work, you may replace it with one
of the two drivers posted on the Spectra Precision website:
http://www.spectraprecision.com/eng/sp90m.html#.WUkG_NxLep0
USB driver for 64-bit OS: SpectraPrecisionUSBSerialSetup_x64.exe file
USB driver for 32-bit OS: SpectraPrecisionUSBSerialSetup_x86.exe file
Double-click on the downloaded file to install the driver.
•
[7]
:
Escape
button. See
Using the Front Panel Controls on
•
[8]
: Bumpers (x2).
Rear Panel
•
[8]
: Bumpers (x2).
•
[9]
: GNSS input #1. A TNC coaxial female connector
allowing you to connect the first GNSS antenna to the
receiver via a coaxial cable.
•
[10]
: GNSS input #2. A TNC coaxial female connector
allowing you to connect the second GNSS antenna to the
receiver via a coaxial cable.
•
[11]
: External GSM antenna (optional). A coaxial female
connector (SMA type) allowing you to connect an external
cellular antenna.
The SP90m having a built-in GSM antenna, no external
GSM antenna is usually required. In case of adverse
reception conditions however (e.g. SP90m mounted in a
rack), an external antenna can advantageously be used for
better reception. Run the Web Server (
Receiver
>
Network
>
Modem
>
Modem Antenna
) to choose which of the internal or
external antenna should be used.
The SP90m uses a GSM antenna when it sends or receives
RTK or differential corrections via its GSM modem.
•
[12]
: UHF radio connector. A TNC coaxial female
connector allowing you to connect a radio whip antenna.
This connector is available only if the SP90m has been
fitted with an internal radio.
[9]
[13]
[17]
[16]
[14]
[15]
[10]
[11]
[12]
[8]
[8]
