Spectra Precision Focus 30, User Manual

Page: 5 / 126

Spectra Precision FOCUS 30 User Guide III
Important Information
Before using the instrument, make sure that you understand this user guide, as well as
all equipment and job site safety requirements.
Safety Information
• Instruments and original accessories from Spectra Precision must only be used
for the intended purpose.
• Operate the instrument only in the compliance with the operating conditions
specified. Do not point the telescope directly at the sun.
• Do not use the instrument and accessories in rooms with danger of explosion.
• Protect operator and instrument sufficiently at the site of measurement (e.g.
construction site, roads, etc.). Observe any relevant national regulations and the
Road Traffic Act.
• Do not carry out surveying work in a thunderstorm to avoid being struck by
lightning.
• Do not modify the instrument.
• Do not use the instrument if there are any visible damages.
• Only authorized Spectra Precision approved service center have permission to
repair this product.
Laser Safety
This equipment has been tested and found to comply with IEC 60825-1 January 2007,
21 CFR 1040.10, and 1040.11 except for deviations pursuant to Laser Notice No. 50,
dated July 26, 2007.
C
Warning – Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous LED or laser radiation exposure. As with any
bright light source, such as the sun, electric welding arcs or arc lamps, common sense
applies.
DO NOT look into the laser aperture when the laser is on. For further information regard-
ing laser safe use of laser, refer to IEC standard 60825-1:2007.
Note –
For security reasons the Spectra Precision
®
FOCUS
®
30 user guide describes
the warnings and regulations of the IEC 60825-1:2007 and the warnings and
recommendations of the German industrial regulation BGV B2 (updated print version
April 2007).
Per this German regulation, a responsible person for laser safety has to be defined.
All absolute vital power to fulfill this task has to be transferred to this person.
Please ensure that you are aware of any national laws and regulations applicable in
the country of operation, concerning laser safety precautions and any other