Spectra Precision Epoch 25 L1, User Manual

Page: 36 / 50

6
Default Settings
34
Epoch 25 L1/L2 GPS System User Guide
6.1
Default settings
These settings are defined in the default application file.
61.1
Default behavior
When you start the GPS receiver, the logging settings are the factory defaults and
logging does not begin automatically. This is true in all of the following situations:
•
it is the first time that the receiver has been used
•
you have reset the receiver to its factory defaults
6.2
Resetting to factory defaults
To reset the receiver to its factory defaults, turn the unit on and off.
Function Factory default
SV Enable All SVs enabled
General Controls: Elevation mask 13°
PDOP mask 7
RTK positioning mode Low Latency
Motion Kinematic
Serial Port 1: Baud rate 38,400
Format 8-None-1
Flow control None
Serial Port 2: Baud rate 38,400
Format 8-None-1
Flow control None
Input Setup: Station Any
Reference position: Latitude 0°
Longitude 0°
Altitude 0.00 m HAE
Antenna: Type Unknown external
Antenna height Dependent on measurement method
Group All
Measurement method Set by field software