Chapter 2. Installing NAStape
16
Connecting the NAStape
Follow these instructions to connect the NAStape unit.
1.
Plug in the power cord.
2.
Turn on the NAStape unit.
Note:
The NAStape will make a high-pitched noise upon start up. This is
normal behavior for the low-voltage sensor in the unit.
There are two interfaces available to configure and set up your options: HTTP and
serial port. Select the appropriate method based on your environment.
DHCP Environment
To use the HTTP configuration application, proceed to
.
Static IP Environment
To use the serial port interface, or if you’re unable to use the
HTTP interface, proceed to
