MX800 Transceiver
Technical Manual
1.6.4 Selecting the tone set
Once in the SELCALL menu, the tone set is selected by, Configuration Menu - Selective Calling
(SELCALL) Menu - Edit SELCALL tone set (
C L 2
), the SELCALL tone menu will then be displayed.
Figure 1-4 SELCALL tone options
The list of tone frequencies and tone durations is given in
Table 1-4 Standard SELCALL Frequencies
and
Table 1-3 Nominal SELCALL Durations
respectively. Among the SELCALL tone set options is the
choice for a custom tone set. This allows the user to specify the tone frequencies and tone durations thus
supporting other less common SELCALL tone sets.
1.6.5 Configuring the SELCALL commands
The SELCALL commands menu allows the user to configure the command tone sequence and enable or
disable each command. The enabling and disabling of commands is done with, Configuration Menu -
Selective Calling (SELCALL) menu - Display SELCALL commands menu - Enable individual
SELCALL functions (
C L 7 9
). The command tone sequence can then be individually defined using the
appropriate menu options, e.g. '1' for 'Repeater Setup' and so forth. The command tone sequence length is
defined in the 'SELCALL CONFIGURATION MENU'. Each command can be individually enabled or
disabled using menu option '9'.
22
© SPECTRA ENGINEERING 2010 Revision 1.0.4