USB Temperature Controller
5
Quick start Guide
1. Correctly install the heated Specac accessory into the Spectrometer
which is to be controlled by the USB Temperature Controller before
proceeding
(See the accessory’s user instruction manual for further
guidance).
2.
Once the accessory’s installation has been completed, connect the
thermocouple and heater leads to the USB Temperature Controller
connections. To help orient the connectors polarity there is a red dot
on the top of each connector.
3. Now connect the desktop power supply DC output cable and the
USB cable to the connections on the opposite side of the USB
Temperature Controller box as shown below.
Accessory heater
power connection
Thermocouple or
RTD connection
Desktop power
supply Connection
USB Cable
Connection to PC