8999070: v3 03/09/2018
Page 6.2 of 6.10 pages
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
WARNING!
Waste oil qualifies as hazardous waste according to current law and, as such, must not be
released into the environment; it should be recovered and disposed of through suitable collection centres.
Consequently, contact your nearest environment agency concerned with the collection and disposal of waste oil before
commencing any maintenance work
6.3
Maintenance work that can be performed by the operator
The work described in the following points does not require any special expertise.
The operator must be familiar with the procedures and follow the relevant instructions carefully, and must put
the machine out of service first.
Routine checks and maintenance work must be performed at the stated intervals following the procedures
given and are the responsibility of the operator; see Section 6.11.
Failure to comply with maintenance rules and intervals has a negative effect on machine operation and its
service life and, consequently, shall void the warranty.
Perform maintenance at shorter intervals when working under demanding operating conditions (frequent
stopping and starting, lengthy winter season, e.t.c).
6.4
P.T.O Shaft
Refer to the manufacturer’s instructions, (supplied with the shaft) to adjust or service the P.T.O. shaft.
6.5
Rotor Gearboxes
NOTE: The Rotor gearboxes are housed underneath the top covers. For access, unscrew the guard fixing bolt on top
of the guard, and remove each guard.
Figure 6.1
6.5.1
Tightening outer gearbox fixing bolts
RH gearbox shown, LH similar
Figure 6.2
