INSTRUCTIONS FOR MODELS
92-SF-9102-02
For additional assistance or service please contact:
SPEAKMAN
®
800-537-2107
www.speakman.com
SF-9102
SF-9202
HELPFUL TOOLS & SUPPLIES:
TOOLS AND SUPPLIES
Adjustable
Wrench
Phillips
Screwdriver
Pencil
Aerator
Wrench
(included)
Mounting
Hardware
(not included)
Drill
3/8"
Wrench
Safety
Glasses
Warranty information can be found at:
www.speakman.com
WARRANTY
MAINTENANCE
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
• This faucet has an operating range of 20-80 psi.
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives may damage the finish and
void the product warranty. Please be sure to only use
approved cleaners. Please contact Speakman for any
clarification of acceptable cleaners.
1
Verify that the Rubber Gasket is in position and
aligned to the base of the Faucet.
2
Place Hose and Sensor Wire carefully, one at a
time, thru hole in mounting surface. Lower Faucet
into position.
3
From below, install Rubber Washer (1), Metal
Washer (2), and secure with Mounting Nuts (3).
Align Faucet to desired position and wrench
tighten Mounting Nuts (3).
OR
4
Assemble the Solenoid "OUTLET" Hose of the
Faucet (1) to the "OUTLET" connection (2) of
Solenoid. Wrench tighten.
DRY CONNECTION ONLY.
DO NOT USE ANY SEALANT
ON THIS CONNECTION
5
Place the Solenoid Assembly against the desired mounting surface while ensuring adequate clearance for
servicing of all connections. If using the optional A/C Adapter, consider the distance to the nearest electrical
outlet. Solenoid Assembly should be mounted so the inlet and outlet ports are aligned vertically. Mark location
of Solenoid Assembly on the mounting surface using a pencil.
10-7/8”
(275mm)
MAX
LEFT OR RIGHT
OF CENTER
9-7/16”
(240mm)
MAX
6
Remove Mounting Bracket (1) from Solenoid Assembly. Using the previously marked location on mounting
surface, align Mounting Bracket (1) horizontally to approximate position and mark the mounting locations with a
pencil. If mounting on drywall and not to stud, use the appropriate anchors and fasteners for application.
Recommend screw in easy anchor or equal for drywall.
IMPORTANT NOTE
Verify that all hoses are free from bends or kinks.
7
After securing the Bracket to the mounting surface, align and slide Solenoid Assembly over Mounting Bracket.
8
Assemble Solenoid "INLET" Supply Hose (1) to
the "INLET" connection (2) of Solenoid. Wrench
tighten.
DRY CONNECTION ONLY.
DO NOT USE ANY SEALANT
ON THIS CONNECTION
9
Ensure the water supplies are turned off. Make
connections with the Hot and Cold hoses of the
faucet to water supplies. The inlet threads of the
faucet are 9/16”-24 UNF and will accept a
3/8” Compression Fitting. Wrench Tighten.
Accepts a 3/8”
Compression
Fitting
SUPPLY STOPS NOT INCLUDED