INSTRUCTIONS FOR MODELS
92-SA-3100-01
For additional assistance or service please contact:
SPEAKMAN
®
800-537-2107
www.speakman.com
SA-3104
HAND TOWEL BAR
SA-3106
ROBE HOOK
SA-3107
TOWEL BAR
SA-3107-18
18”
TOWEL BAR
SA-3110
PAPER HOLDER
TOOLS AND SUPPLIES
Phillips
Screwdriver
Pencil
Drill
Drill Bit
Ø
7
/
16
”
Drill Bit
Ø
1
/
4
”
Level
Hammer
Measuring
Tape
Phillips
Drive Bit
Warranty information can be found at:
www.speakman.com
WARRANTY
MAINTENANCE
• Be sure to wear eye protection.
• If mounting to a tile surface, ensure you acquire
appropriate mounting hardware capable of supporting
the accessory in use. Follow the instructions included
with the manufacturer’s mounting hardware.
SAFETY TIPS
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives on any of the Speakman custom
finish products may damage the finish and void the
product warranty. Please be sure to only use approved
cleaners. Please contact Speakman for any clarification
of acceptable cleaners.
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
•
This installation manual covers several models.
While the appearance of your model may vary,
the installation steps required are the same as
shown in this manual.
• This item is NOT designed for use as a grab bar.
Do not mount in locations where product is likely
to be used as a grab bar.
1
If Accessory comes pre-assembled, remove
the Set Screw(s) (1) on the bottom of the
Mounting Bracket(s) using a Philips Head
Screw Driver. Remove the Toggle Anchor(s)
and Mounting Hardware (2).
2
At the selected height, mark center point of
mounting locations onto wall referencing
the rough in diagram.
3
If mounting to dry wall, use the Plastic
Toggle Anchors (included). Drill guide holes
at marked locations using a Drill equipped
with a
Ø
7/16" bit.
NOTE:
If mounting
to tile, acquire appropriate hardware and
follow manufacturer's installation guidelines.
Ø
7
/
16
”
OR
