6. Handlebar and Computer Installation
Remove four M5x12 Bolts (57) from the back of the Computer (56). Remove bolts with the
Multi Hex Tool with Phillips Screwdriver provided.
Remove two M8x16 Bolts (41) and two Ø16xØ8x1.5 Curve Washers (93) from the Front
Post (5). Remove bolts with the S6 Allen Wrench provided.
Insert the Hand Pulse Sensor Wires (58) from the Handlebar (6) into the hole on the Front
Post (5) and then pull them out from the top end of the Front Post (5).
Attach the Handlebar (6) onto the Front Post (5) with two M8x16 Bolts (41) and two
Ø16xØ8x1.5 Curve Washers (93) that were removed. Tighten bolts with the S6 Allen
Wrench provided.
Connect the Sensor Wire I (67) and Hand Pulse Sensor Wires (58) to the wires that come
from the Computer (56) and then attach the Computer (56) onto the top end of the Front
Post (5) with four M5x12 Bolts (57) that were removed. Tighten bolts with the Multi Hex
Tool with Phillips Screwdriver provided.
6 .
OPERATING THE COMPUTER
Allen Wrench S6
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Tool:
Summary of Contents for 1331
