
Snorkel Mask Instruction Manual
ENGLISH
Preparation:
It is helpful to clean the mask before each use to remove any residue. A new diving mask may also contain
silicone residues from the manufacturing process. Apply a small blob of mild toothpaste to the inside of the
mask and brush gently in circular movements. Rinse the mask and dry it with a cloth. Repeat the procedure if
necessary. When the mask is clean and ready to use, attach the snorkel. Make sure the snorkel is free of dirt
and air can enter the mask.
Seal check:
Pull the mask straps over your head and check that the mask fits well on your face. Continue to breathe
normally to see if it is leaking. If you feel a slight pressure while breathing, the mask will fit perfectly. If the
mask does not fit properly, air circulation may be impaired and the inside of the mask may fog up. If it is too
tight or too loose, remove the mask and adjust the straps properly. (DO NOT ADJUST THE STRAPS TOO
TIGHTLY!). It is best to remove any facial hair as it may affect the fit of the mask and cause it to leak.
Use:
When you are in the water, stay on the surface and breathe evenly through your nose or mouth. If you begin to
feel dizzy, remove the mask immediately. Breathing with the tube works best when you lift your chin slightly.
If water enters the mask, head to the surface and the water will run out of the valve on the chin by itself. You
do not need to remove the mask.
Care instructions
Clean the mask with tap water and a little detergent. Wipe with a microfibre cloth or a very soft towel to avoid
water stains and then air dry. Store
the mask protected from the sun. Do not leave the mask in the sand when not in use.
Fixing the snorkel:
1. slide the snorkel over the holder on top of the mask. The plastic tab on the snorkel tube should be behind the
mask.
As soon as the tube touches the O-ring seal, press firmly until the tube is recessed into the mask holder.
3 Do not wait for a click noise. Visually check the seal. Do not force the tube to the mask. The tight fit prevents
water from entering.