Sparc E35202-05, Installation Manual

Page: 41 / 62

Power On the Host Through the CMM SER MGT Port (CLI)
Powering On the Server Module for the First Time 41
Note -
You can perform other Oracle ILOM commands while the server initialization continues
in the background. To return to Oracle ILOM, type
#.
(Hash Dot). To see information about
available Oracle ILOM commands, type
help
. To return to the initialization, type:
start /HOST/
console
.
8. The server module hardware installation is now complete.
You can now configure the server module to meet your needs. See “Configure the Preinstalled
OS” on page 44 .
Related Information
■
“Plan Communication With the Server Module During Installation” on page 22
■
“Dongle Cables” on page 24
Power On the Host Through the CMM SER MGT
Port (CLI)
You can access the server module SP by first accessing Oracle ILOM CMM through a terminal
or terminal emulator connected to the RJ-45 serial port on the chassis. Then you can connect to
the server module SP through the Oracle ILOM CMM CLI.
1. Verify that the terminal, laptop, or terminal server that will connect to the chassis
is operational.
2. Configure the terminal device or terminal emulation software with these settings:
■
8N1 (eight data bits, no parity, one stop bit)
■
9600 baud (the default, but can be set to any standard rate up to 57600)
■
Disable hardware flow control (CTS/RTS)
3. Connect a serial cable from the CMM serial port to the terminal device.
Refer to the modular system documentation for the location of the CMM serial port.
The serial port requires a cable with these pin assignments.
Pin Signal Description
1 Request To Send (RTS)
2 Data Terminal Ready (DTR)
3 Transmit Data (TXD)