Spa-Quip Digital 2000 Series, User Manual

Page: 1 / 2

QUICK CARD - USER GUIDE FOR THE
DIGITAL 2000 SERIES SPA CONTROLLERS
DUAL SPEED VERSION
Dealer Stamp:
Digi2000Prelim-V2,DS NRC
Please read these instructions carefully
Miscellaneous:
The switch normally beeps every time a button is pushed. These
can be switched off by holding down the Up button and
simultneously pushing the Light button. To switch on again repeat
the above.
The Display normally always returns to the pool temperature. If
you want the display to stay on Time, then pushing the display
button until time is shown and pressing the Down button will lock
the display in this mode. The temp display can be restored at any
time by pushing the Display button.
Heating Indicator:
& Load Shedding
This indicator shows when the pool is being heated. It
will turn on and off automatically in Auto and Manual
modes when heating is required.
Load Shedding
( keeping power within design limits ) is an arrangement
predefined at manufacture which, dependent on system and
components used, will switch either the heating element or
accessories on and off to keep within the Controllers power
limits.
Manufactured By:
Spa-Quip Ltd
Cnr Rothwell Ave & Albany Hwy
North Harbour Industrial Park
Auckland, New Zealand
Ph (649) 415 8622, Fax (649) 415 8621
Email: ampac@ihug.co.nz
Australian Distribution and Service:
Spa-Quip (Australia) Pty Ltd
Unit 2A, 4 Hudson Ave
Castle Hill NSW 2154
Ph (612) 9634 5600, Fax (612) 9634 5900
Email: aqua@fl.net.au
Warning:
If the supply cord is damaged, it shall be
replaced by the manufacturer or its
service agent or similarly qualified person
in order to avoid hazard.