SP Controls Application Note
Mitsubishi xD300U
Revision D
I. Driver Features
1. Command Format
This device is controlled through RS-232.
2. RS-232 Commands
Power On
Power Off
Volume Up
Volume Down
Source: Video 1
Source: Video 2
Source: Computer 1
Source: Computer 2
Menu
Adj Up
Adj Down
Adj Left
Adj Right
Enter
P in P
Expand
Mute On
Mute Off
Auto Position
Still
Keystone
Keystone Up
Keystone Down
3. Other Driver Features
Default Power Status Feedback
:
Projector Restart Lockout Timer (Default)
:
RS-232 Polling
77 Seconds
II. RS-232 Control Wiring
Wire RS-232 control to a male DB9 as follows:
Connect male DB9 to the intermediate Mitsubishi adapter cable (not included). Connect adapter cable to
projector port labeled
RS-232C
.
Serial Adapters
(for NRC only): A and B
Alternate Wiring
: If you do not have the Mitsubishi serial adapter cable, terminate the SP Controls control
cable directly on a male 8-pin mini-DIN as follows:
Connect the male mini-DIN to the projector port labeled
RS-232C
.
© 2003-9 SP Controls Inc.
SP Controls reserves the right to modify specifications without notice at any time.
GND to 5
RX to 2
TX to 3
SP Controls
Device
Control Cable
(shown from front)
3
4
5
8
7
6
2
1
GND to 4
RX to 7
TX to 1
SP Controls
Device
Control Cable
(shown from front)
