SP Controls Application Note
Epson EMP-7800
Revision F
I. Driver Features
1. Command Format
This device is controlled through RS-232.
2. RS-232 Commands
Power On
Power Off
Volume Up
Volume Down
Source: Video (RCA)
Source: S-Video
Source: BNC (RGB-Analog)
Source: BNC (RGB-Video)
Source: YCbCr (BNC)
Source: YPbPr (BNC)
Source: Computer (VGA)
Source: DVI
Menu
Adj Up
Adj Down
Adj Left
Adj Right
Enter
Escape
Bright Up
Bright Down
Help
Resize
A/V Mute
E-Zoom Up
E-Zoom Down
Sync Up
Sync Down
Tracking Up
Tracking Down
3. Other Driver Features
Default Power Status Feedback
:
Projector Restart Lockout Timer (Default)
:
RS-232 Power Polling
42 Seconds
II. RS-232 Control Wiring
Wire RS-232 control to a female DB9 as follows:
Connect female DB9 to projector port labeled
Control (RS-232c)
.
Serial Adapters
(for NRC only): None
III. Projector Configuration
The Epson EMP-7800 projector
must be configured
to STANDBY MODE: NETWORK ON in the
projector onscreen menu ADVANCED1. If the projector STANDBY MODE is not configured to NETWORK
ON, it may stop responding to RS-232 commands. If the projector does stop responding to RS-232
control, manually power down the Epson projector. Once the projector cools down, unplug the projector
from the outlet and allow it 15 seconds to reset. Reapply power and the projector should work normally.
Note
: When the projector is placed in
STANDBY MODE: NETWORK ON
the projector fan remains on in
standby mode. This is normal projector behavior.
© 2004-9 SP Controls Inc.
SP Controls reserves the right to modify specifications without notice at any time.
GND to 5
TX to 2
RX to 3
SP Controls
Device
Control Cable
(shown from front)
