14
Operating instructions UVR-300/UVR-400 | Heinz Soyer Bolzenschweißtechnik
2.5
Intended use of the stud welding systems
The devices (universal feeders UVR-300 and UVR-400) described here require
additional components for automatic operation.
Stud welding device with feeder interface, e.g. BMS-9 Automatic
Automatic stud welding gun or head
Typical application areas for the automatic feed of welding fasteners are as follows:
Stationary robotic stud welding machines
Stationary CNC stud welding machines
Mobile hand-operated stud welding machines
For the sake of simplicity, only a hand-operated stud welding system is
described in these operating instructions.
For example, in connection with the energy source BMS-9 Automatic and the stud
welding gun PS-3A, the studs can be fed into the gun automatically using compressed
air.
These operating instructions and the declaration of conformity only apply if the
named devices are used together as described in these operating instructions.
In automatic mode, the universal feeders may only be operated with the accessories
described in these instructions.
Operation of the stud welding system must be in accordance with the technical data.
Special studs or diameters upon request.
The devices described here can also be operated separately in other
combinations. In case of using a stationary robotic or CNC stud welding
machine, the respective operating instructions of the devices must also be
observed.
2.5.1
Incorrect use
Any use of the devices deviating from the intended use is considered improper use.
Non-intended use, unauthorised modification, separate device operation or manip-
ulation of the devices will void the declaration of conformity and warranty claims against
the manufacturer.