Pg. 1
Assembly Instructions:
Make sure the Playhouse is in the room where it will be used before assembly, as it cannot be moved from room to room
once it is assembled.
1.
M
o
ve
the Platform close to the area where it will be permanently stationed. To install the step hand rail post screw 4 joint
connectors through the bottom step on the same side the steps will be used on the platform into the step post on the exte-
rior side.
2.
Start with the platform that will have the steps connected.
Place platform on back side.
Connect two rear legs to platform
(you will only be able to use 2 joint connectors from the sides at this point.)
Connect front inside leg with 4 joint connect-
ors.
Rotate platform onto the 3 connected legs, being careful not to apply pressure to legs while rotating.
Install remaining
4 joint connectors to rear legs.
Lift platform slightly and slide step assembly underneath outside corner of platform.
Con-
nect with 6 joint connectors.
Repeat procedure to remaining platform, adding all 4 legs.
3.
Move Platform 1 and Platform 2 together . This will line up Platform
2’
s middle post with Platform
1’
s middle post. Now
from underneath the platforms attach them together using two button head Allen bolts with one lock washer and one flat
washer each.
Tighten together using the Allen wrench provided. Screw 2 joint connectors into rear bracket located on the
back of the middle posts. Do not tighten completely until you make certain that Platform 1 and 2 are aligned
-
then tighten
completely.
4.
Slide the Step Plexiglass into place and install the hand rail over the plexiglass with the T to the top. Screw two joint con-
nectors into Platform
’
s hand rail first. Then two joint connectors into the post you will need to push the post all the way to
the plexiglass. Apply only enough pressure to the post so it touches the plexiglass.
5.
To install the slide attach the bottom half of the slide to the top half using six button head Allen bolts with one lock washer
and one flat washer. Once together, move into place on Platform and install 2 button head Allen bolts with one lock wash-
Materials:
2
-
Platforms (1) (2)
1
-
Step Handrail
9
-
Legs
2
-
Ramp Sections
1
-
Step Plexiglass
1
-
Instruction Sheet
1
-
Set of Steps
5
-
Carpets
1
-
Maintenance.Checklist
Hardware Bag
46
-
Joint Connectors
1
-
4mm Drill Driver
10
-
Lock Washers
1
-
7/32”
Allen Wrench
10
-
Button Head Allen Bolts
1
-
4mm Allen Wrench
10
-
Flat Washers
Important Notes
(please read before assembling)
Assembly can be done with only the hex wrench provided. However, we strongly recommend using a cordless drill with the
4mm hex driver to speed assembly. Take care to set the drill
’
s torque so that it drives the screw fasteners completely with-
out stripping them out. Also, make sure the drive is seated properly in the screw, or the driver can strip out the head of the
screw fastener
The Playhouse can easily be assembled with two people, and it is not extremely heavy. However, it may be prudent to
have a third person available, depending on the strength of those helping with the assembly process.
Instruction Sheet
Multi
-
Level Playhouse
-
150260
Store these instructions in a safe place or
you may access them on our website.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file this
Instruction Sheet in an accessible location. The Instruction Sheet must be read and familiar to anyone who is using
Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.
If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
