EA-R03 Wireless Keypad Controller Kit
Operating Instructions
J-EA-R03-M_revC
visit
www.southco.com
for latest version of this document
Page 1 of 4
Package Contents
EA-R02-202 Receiver
EA-R03-103 Wireless Keypad Transmitter
Keypad Mounting Packet
Power/Auxiliary Connector Wire Harness
Lock/Unlock Relay Connector Wire Harness
User Instructions
EA-R03-103 Wireless Keypad Transmitter
1 · 2
3 · 4
5 · 6
7 · 8
9 · 0
1 · 2
3 · 4
5 · 6
7 · 8
9 · 0
EA-R02-202 Receiver
1.
Antenna
2.
Access Tab for Programming Switches
Features
Receiver supports up to four transmitters (one pre-programmed
wireless keypad transmitter included with kit)
Re-programmable user code (3 to 7 digits)
Selectable LOCK/UNLOCK pulse duration (250ms or 10sec)
Backlit keypad keys
Two user-configurable lock/unlock relay outputs
One 12V auxiliary relay output.
Specifications
Receiver Power:
12VDC (±10%)
Receiver Idle Current:
10mA (maximum), no attached devices
Receiver Operating Current:
100mA (maximum), no attached devices
Receiver Outputs:
three Form C relays, rated 15A at 14VDC
Receiver Operating Temp:
-20 to 80°C
Operating Range:
up to 60 feet / 18 meters (open air)
Operating Frequency:
433.92MHz
Coding Type:
Fixed Code (24-Bit)
Transmitter Power:
Type CR2032 3VDC battery
Normal Use
The keypad transmitter can be used to lock and unlock the system.
Unlocking the System
Enter the user code (default 1234), then press the 1·2 button. The system
will unlock and the auxiliary output will pulse twice, as shown in the figure
below:
UNLOCK Sequence (pulse set for 250ms)
UNLOCK Sequence (pulse set for 10 seconds)
Locking the System
Enter the user code (default 1234), then press the 3·4 button. The system
will lock and the auxiliary output will pulse once, as shown in the figure
below:
LOCK Sequence (pulse set for 250ms)
LOCK Sequence (pulse set for 10 seconds)
Pulsing Auxiliary Output
Enter the user code (default 1234), then press the 5·6 button. The auxiliary
output will pulse five times, as shown in the following figure:
