OPERATION
South Bend Tools
For Machines Mfd. Since 10/21
Model SB1118
-27-
O P E R A T I O N
Operation Overview
To reduce the risk of
serious injury when using
this machine, read and
understand this entire
manual before beginning
any operations.
The purpose of this overview is to provide
the novice machine operator with a basic
understanding of how the machine is used during
operation, so they can more easily understand
the controls discussed later in this manual.
Note:
Due to the generic nature of this overview,
it is not intended to be an instructional guide for
performing actual machine operations. To learn
more about specifi c operations and machining
techniques, seek training from people experienced
with this type of machine, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce risk of short and
long term injury, wear eye,
ear, and lung protection
when using this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any projects.
Regardless of the content in this section,
South Bend Tools will not be held liable for
accidents caused by lack of training.
1.
Examines workpiece to make sure it is
suitable for planing.
2.
Puts on safety glasses or face shield, a
respirator, and hearing protection.
3.
Places workpiece on table with flat side down
and correctly adjusts bed roller height and
table elevation for workpiece thickness and
depth of cut.
— If workpiece is bowed, operator surface
planes workpiece on a jointer, with
cupped side facing down, until one side is
flat. Doing so ensures that it sits solidly
on planer table during operation.
4.
When all safety precautions have been
taken, starts dust collector, then turns
planer ON.
5.
Stands to one side of planer path to reduce
risk of kickback injuries, then feeds
workpiece into planer until infeed roller
grabs it.
Note:
Infeed and outfeed rollers control feed
rate of workpiece as it passes through planer.
Operator does not push or pull on workpiece.
— If cut is too deep and bogs down planer,
operator immediately reduces depth of
cut.
6.
Once workpiece is clear of outfeed roller and
stops moving, operator removes workpiece
from outfeed table and measures workpiece
thickness. If further planing is required,
operator raises table slightly, then feeds
workpiece into front of planer again.
7.
Operator continues process until desired
workpiece thickness is achieved, then turns
planer OFF.
To complete a typical operation, the operator
does the following:
