SoundTube SB335 Installation Instructions Manual Download Page 8

Page: 8 / 8

SB335 |

SB335

Install Instructions For:

To satisfy FCC

IC RF exposure requirements, a separation distance of 20 cm or more should be maintained between the antenna

of this device and persons during device operation.

To ensure compliance, operations at closer than this distance is not recommended.

Les antennas installees doivent etre situees de facon a ce que la population ne puisse y etre exposes a une distance de main de

20 cm. Installer les antennas de facon a ce que le personnel ne puisse approcher a 20 cm ou mains de la position centrals de I'

antenna.

FCC des eltats-unis stipule que cet appareil doit etre en tout temps eloigne d'au mains 20 cm des personnes pendant son

functionnement.

This radio transmitter (IC: 7756A-MSE3CHA ) has been approved by Industry Canada to operate with the antenna types listed

below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not

included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this

device.

Gain of antenna: 2.0dBi max.

Type of antenna: Omni-directional

Impedance of antenna: 50ohm

Le present emetteur radio (IC: 7756A-MSE3CHA) a ete approuve par lndustrie Canada pour fonctionner avec les types d'antenne

enumeres ci-dessous et ayant un gain admissible maximal et !'impedance requise pour chaque type d'antenne. Les types

d'antenne non inclus dans cette liste, ou dont le gain est superieur au gain maximal indique, sont strictement interdits

pour !'exploitation de l'emetteur.

Gain d'antenne: 2.0dBi maximal

Type d'antenne: 50 ohm, Omni-directionnel

Summary of Contents for SB335








