12
ENGLISH
ZEPHIRO 1000ST HAZE User manual
f
In the first time use, some liquid might spray out. This is normal.
f
When liquid is getting low, please add it again in time. If the fog machine works
without fluid for a long time, its pump and other parts could get damaged. When
adding fluid, remember to turn power off, and carefully avoid spilling over to cause
short circuits.
f
The haze machine should work under professional operator’s supervision, please
do not add flammable liquids, gas or perfume into the fog fluid tank.
f
When working, do not touch power cord.
f
When you don’t use the machine for long time or after use, please disconnect
power or unplug the power cable.
f
After using, please wipe out the liquid in the tank, as it would avoid the housing to
be corroded.
f
All haze machines will have condensation or moisture around the Output Deflector.
f
All haze machines have heating-cooling cycles. When internal temperature drops
to minimum, the pump automatically turns on and begins heating. Once heating is
complete, the machine starts to spray haze again.
f
In the case of a serious operating problem, stop using the unit immediately. Never
try to repair the unit by yourself Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center Always use the same type of spare parts
f
Never connect the device to a dimmer pack
f
Make sure the power cable in never crimped or damaged and never disconnect it
by pulling or tugging on the cable.
Fog machines may set off Smoke Alarms
10. ROUTINE MAINTENANCE AND COMMON FAULTS
Periodically clean your machine to reduce replacement parts and repair ex-
penses.
f
Poor haze liquid can cause blockage. It is recommended to use high quality haze
liquid.
f
The machine might get blocked due to high concentration fluid, not-pure fluid or
overheat, so regular care and maintenance can ensure long-term use. After about
40 hours continue use, please prepare an 80% distilled water and 20% white vine-
gar blend to remove any accumulated impurities inside boiler and pipe, as follow-
ing:
1. Wash the pipe in the tank and its filter head.
2. Pour out any liquid inside, and replace with the cleaning liquid (80% distilled
water and 20% white vinegar), turn on power, keep it operating till the clean-
ing liquid runs out.
