Select menu icons
Numbers change
f
Once you have located an interference-free channel (see “11. FREQUENCY TABLE”
at page 21 for details), rotate SETUP knob, and press it to enter into the channel
setting mode while GR/CH is highlighted.
f
Then rotate the control knob to select the appropriate menu item (GR or CH) and
press the knob to confirm.
f
Select the appropriate group and channel by increasing or decreasing and, after
finished, press the control knob to confirm.
f
Finally press IR function to sync the receiver with the handheld transmitter or
bodypack.
NOTE: If during group/channel selection you do not press any button for
about 10 seconds, the system automatically returns to the LOCK mode. It is
therefore necessary to unlock the receiver again to re-access group/channel
setup mode.
8.3. Auto Scan Mode
SOUNDSATION WF-D190 MKII is equipped with a useful auto scan function of the
frequencies. This allows you to always choose those channels with less problems and
make setting operations extremely quick.
f
To automatically perform a frequency scan, unlock - if not already done - the receiver
by holding for a few seconds UNLOCK button (LOCK icon disappears).
f
Then press SETUP knob and rotate it clockwise or counterclockwise until SCAN menu
is reached.
f
Press SETUP knob again to enter SCAN menu. You fill find two options: UP or DOWN.
The first performs a spectrum scan and returns the first free frequency above the
current one. The second scans the spectrum but returns the first free frequency
below the current one.
f
Then rotate the control knob and select UP or DOWN to automatically scan up or
down to search for available frequency.
15
ENGLISH
WF-D190 MKII User manual
