12
ENGLISH
PAR-5-18W-IP65 User manual
5. MENU
- Press this button to enter the menu
6. DOWN
- Press it to pass to previous menu
7. UP
- Press to go to next menu
8. ENTER
- Press to choose the selected function
6.1. Fixture Setup
DMX Address
Press MENU button to reach
Addr
page. Then press ENTER to adjust from 1 to 255.
Then press ENTER again to confirm.
NOTE: During setup process, if you don’t press any buttons for about 5-6 sec
-
onds, the display will automatically go back to home page; all changes won’t
be confirmed, and the display will show last active mode (DMX, or Auto, or
Sound, etc.).
Channel Mode
Press MENU button repeatedly to reach
ChNd
page. You can then choose among seven
different modes with different number of DMX channels from 2 to 9. Please read the
section “7. DMX MODE CHARTS” on page 15 for further details.
Press ENTER and then UP or DOWN to browse among
2Ch
,
3Ch1
,
3Ch2
,
4Ch
,
5Ch
,
6Ch
, and
9Ch
. Then press ENTER again to confirm.
Master/Slave Mode
Press MENU button repeatedly to reach
SlNd
page. This function allows you to set the
unit as master or slave. It is used in case you want to control several PARs without a
DMX controller. The first fixture in the chain will be set as master; the rest as slaves.
Press ENTER and then UP or DOWN to choose between
Nast
or
SlaU
. The press ENTER
again to confirm.
SHOW Mode
Press MENU button repeatedly to reach
ShNd
page. This function allows you to choose
among four show types:
Auto Run (
ShoU
)
- The fixtures randomly run color/jump/fade/ programs. To activate
run mode, when you are in
ShNd
page, press ENTER and then UP or DOWN to reach
