SOUND FUSION Equine DR II, Service Manual

Page: 51 / 178

Service Manual: FUSION EQUINE DR® | 33
2. Safety, Warranty, and Licensing Information
Warning: Portable RF communications equipment (including
peripherals such as antenna cables and external antennas) should
be used no closer than 30 cm (12 inches) to any part of the FUSION
EQUINE DR
®
system, including cables specified by the manufacturer.
Les équipements portatifs de communications RF (y compris les
périphériques tels que les câbles d’antenne et les antennes externes)
ne doivent pas être utilisés à plus de 30 cm (12 pouces) de n’importe
quelle partie du prochain système FUSION EQUINE DR
® , y compris
les câbles spécifiés par le fabricant
Use the following guidance tables for emissions and separation distances:
Table 20: Emissions
— FUSION EQUINE DR
®
II equipment and systems
Emissions test Compliance Electromagnetic environment guidance
RF emissions
CISPR 11
Group 1
FUSION EQUINE DR ® uses RF energy
only for its internal function; therefore, its
RF emissions are very low and unlikely
to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class A or B Class A
Harmonics IEC
61000-3-2 Class A, B, C, D or
NA
Class A
Flicker IEC
61000-3-3
Complies or NA Complies
FUSION EQUINE DR
®
is suitable for
use in all establishments other than
domestic and those directly connected
to public low-voltage power supply
network that supplies buildings used for
domestic purposes.
Table 21: Electromagnetic Immunity
— All equipment and systems not life-supporting
Immunity test
EN/IEC 60601
test level
Compliance
level
Electromagnetic
environment
— guidance
ESD EN/IEC
61000-4-2
±8 kV contact
±15 kV air ±8 kV contact
±15 kV air
Floors should be wood,
concrete, or ceramic tile. If
floors are synthetic, relative
humidity should be at least
30%.
EFT EN/IEC
61000-4-4 ±2 kV mains
±1 kV I/Os ±2 kV mains
±1 kV I/Os
Mains power quality
should be that of a typical
commercial or hospital
environment