- 30 -
SORHEA
G-FENCE
Note: Install 2 sensors on each panel upon which Control Units (UG) are installed
2. Fix the cable along the length of the fence using the provided tie-wraps.
Put a tie-wrap at the end of the panel towards the pole.
3.3 Installation of Termination / Link Unit (UT/UR)
Install the Termination / Link Unit by fixing the 2 higher tie-wraps to an intersection of the fence
mesh.
Fix the bottom of the unit with 2 other tie-wraps.
Sensor 1
Detector cable 1
Control
Unit
Sensor 1
Detector cable 2
Tie-wraps
Tie-wraps at end of panel
Do not lower the cable more than 50 cm / 20 in, in
the direction of the ground.
Tie-wraps installed on the
intersection of the fence mesh
2 other tie-wraps