Loop
SORG
12
2.2.2 Widening the frame
To widen the frame:
• (1+2)
remove both wheels,
• remove the screwing
(A)
from the crossbars
(B)
completely on one side,
• (2)
remove the screwing
(C)
from the seat board
including the shell
(D)
completely.
• Displace both crossbars
(1B)
in the necessary size
along the prepared holes on the crossbar adapters
1 or 2 cm by putting the screws
(1A)
loosely back
in.
• Place one or two shells
(2E)
on the outer side (1
shell=1 cm, 2 shells=2 cm),
• place the screwing
(2C)
back through the shell.
• Tighten all screw connections
(1A and 2C)
.
• Precede the same with the screw connections
(1A
and 2C)
on the other side.
�
INDICATION
Please regard the next chapter if your LOOP has an addi
-
tional crossbar.
ATTENTION
Both crossbars must be displaced in the same distance
on both sides. An asymmetrical assembly is dangerous
and not allowed!
2.2.3 Additional crossbar
To fixate the additional crossbar under the seat:
• (3)
remove both wheels,
• then remove the screw connections, completely
on one side, of the bottom crossbar as described
above,
• on the same side, remove the screw connections
(A)
for the seat board,
• place the crossbar adapter
(B)
for the top crossbar
(C)
in and screw it onto the frame pipe with the
screw
(D)
.
• Place the top crossbar
(C)
in the wanted hole of
the crossbar adapter
(B)
,
• with the screws
(E)
, screw them together in the
same hole as the bottom crossbar,
• place or displace the shells from the seat screwing
(A)
as described above,
• put the screws
(A)
back into the seat board and
tighten them firmly.
• Precede the same way on the opposite side.
ATTENTION
The crossbars must be displaced in the same distance on
both sides. An asymmetrical assembly is dangerous and
not allowed!
(1)
(3)
(2)
(2)
(A)
(C)
(C)
(B)
(D)
(B)
(C)
(D)
(E)
(E)
(A)
