14
Changing the operative direction
The operative direction of controls is factory-set
as shown below.
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
Press
(SEL)
for 2 seconds while
pushing the VOL control.
Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press the select button repeatedly
until “BAL,” “FAD,” “LPF” or “SUB”
appears.
Each time you press the select button, the
item changes as follows:
LOW
*
1
t
MID
*
1
t
HI
*
1
t
BAL (left-right)
t
FAD (front-rear)
t
LPF (low pass filter)
*
2
*
3
t
SUB (subwoofer volume)
*
2
*
4
*1
When EQ3 is activated (page 16).
*2
When “SUB” is selected (page 15).
*3
The cut off frequency is adjustable to 78 Hz,
125 Hz or OFF.
*4
The volume level is adjustable between –10
and +10 steps. (Below –10, “ATT” is displayed.)
2
Rotate the volume control dial to
adjust the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
(With the rotary commander or the card
remote commander)
Press
(ATT)
.
After “ATT-ON” momentarily appears,
“ATT” appears in the display.
To restore the previous volume level, press
(ATT)
again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
To increase
To decrease
