45
Playback
Cha
p
te
r 4
Re
c
o
rdin
g, Pl
ay
bac
k
a
nd Copy
When the unit is in continuous playback mode and some
clips are selected for pulldown playback, continuous
playback of the selected clips is performed in the specified
format of pulldown playback (1080/23.98P or 720/
23.98P).
Timecode in pulldown playback
During pulldown playback, timecode is also converted to
30-frame timecode to match the output video signals.
The upper row of the time data display area displays the
original 24-frame timecode, and the lower row displays the
30-frame timecode.
You can superimpose the 30-frame timecode after
pulldown on an external monitor. To do so, set setup menu
item 005 DISPLAY INFORMATION SELECT to “time
data only”.
Playback operation
This section describes the following types of playback:
Normal playback:
Playback at normal speed
Playback in jog mode:
Variable-speed playback, with the
speed determined by the speed of turning the jog dial
Playback in shuttle mode:
Variable-speed playback, with
the speed determined by the angular position of the
shuttle dial
Playback in variable mode:
Variable-speed playback,
with the speed finely determined by the angular
position of the shuttle dial
Normal playback
First insert an SxS memory card.
For details of how to insert an SxS memory card, see
“Inserting/removing an SxS memory card” (page 37).
To start playback
Press the PLAY button in continuous playback mode.
Playback starts.
When two or more clips are recorded on the SxS memory
card, they are played back continuously.
No sound is output when non-audio signals are played
back.
To jump to the next or previous clip, then start
playback
Use the PREV button, NEXT button, jog dial, or shuttle
dial.
To stop playback
Press the STOP button.
If you play back to the end frame of the last clip, playback
automatically stops.
If, in this state, you press the PLAY button, the message
“Media End!” appears on the display.
To carry out playback again, move back to the desired clip
using the PREV button, jog dial or shuttle dial.
To set shot marks
While playing back an SxS memory card, you can set
essence marks such as Shot Mark1 and Shot Mark2 in
desired frames.
To set a Shot Mark1 or Shot Mark2, hold down the
V
/
MARK1 or
v
/MARK2 button and press the PUSH SET
knob.
You can also delete and modify essence marks from the
Thumbnail Menu of the chapter thumbnail screen
.
Note
Note
1
PREV button
2
PLAY button
3
NEXT button
4
STOP button
5
Jog dial
6
Shuttle dial
7
V
/MARK1 button and
v
/MARK2 button
