Sony XDCAM PDW-V1, Operation Manual

Page: 81 / 109

Chap
te
r 7
Men
u
s
81
7-3 Extended Menu
a) This is supported from firmware version 1.4.
707 FORCED VERTICAL
INTERPOLATION
OFF The “Y-add” function is normally switched on automatically during jog or
variable speed playback. This item selects whether or not to force the “Y-
add” function off.
auto : Automatically switch the “Y-add” function on.
off (forced YADD off) : Force the “Y-add” function off.
The “Y-add” function is off when the unit enters stop mode.
The “Y-add” function is a circuit operation to interpolate the video signal
vertically during jog or variable speed playback for the purpose of reducing
the vertical movement of the playback picture.
713 VIDEO SETUP
REFERENCE
OUTPUT LEVEL Select whether to add the setup (7.5%) to the output analog video signals
(when 525(U) or 525(J) line mode is selected).
0.0% : Do not add.
7.5% : Add.
The factory default settings for each line mode are as follows:
525(U) line mode: 7.5%
525(J) line mode: 0.0%
715 VIDEO GAIN
CONTROL Adjust the video output level.
–512 to 0 to 511
716 CHROMA GAIN
CONTROL Adjust the chroma output level.
–512 to 0 to 511
717 CHROMA PHASE
CONTROL Adjust the chroma phase.
–128 to 0 to 127
718 SETUP LEVEL
(525(U)/525(J) line
modes)/BLACK
LEVEL (625 line
mode) Adjust the setup level (black level).
–512 to 0 to 511
731 WIDE MODE
a)
Specify whether to add wide picture information recorded on a disc to the
output signal during MPEG IMX playback.
thru (through) : Output the video signals of the disc being played back
without adding wide picture information.
auto : When wide picture information is detected on the disc being played
back, add wide picture information to the output video signals.
Notes
• To add wide picture information to the output signal, it is necessary, in
addition to setting this item to “auto,” to operate extended menu item 703
to set line 20 (in 525 line mode) to “thru” or set line 23 (in 625 line mode)
to “thru.”
• In 525 line mode, wide picture information may not be output if VITC
signal insertion position is set to line 20 in extended menu item 601 or
602.
Menu items in the 700s, relating to video control
Item number Item name Settings
Menu items in the 800s, relating to audio control
Item number Item name Settings
802 DIGITAL AUDIO MUTING IN
SHUTTLE MODE Set the audio muting conditions during shuttle playback.
off
: Not muted.
on : Muted.
823 NON-AUDIO FLAG PB Control non-audio flags in digital audio output.
Sub-item
1 CH1/CH2 During playback (except E-E mode), set non-audio flags in digital audio
output to the following states.
on : Set to on (data is non-audio)
auto : Set as follows.
•When data is read from disc and confirmed: Follow the data.
•When data from disc is not confirmed: Maintain current state.
2 CH3/CH4
3 CH5/CH6
4 CH7/CH8