Sony XDCAM PDW-HR1, Operation Manual, Page: 69 / 214

69
Playback
Cha
p
te
r 4
Re
c
o
rdin
g
a
nd Pla
y
b
a
c
k
To set a Shot Mark1 or Shot Mark2, hold down the
V
/
MARK1 or
v
/MARK2 button and press the PUSH SET
knob or the SET button.
You can also delete and modify essence marks from the
Thumbnail Menu of the chapter thumbnail screen
(see
page 81) .
To set a clip flag
You can set one of the three types of flag (OK, NG or
KEEP) for the clip while it is being played back by
viewing its video image and using the function menu
(see
page 60) .
Playback in jog mode
In jog mode, you can control the speed of playback by the
speed of turning the shuttle/jog dial. The playback speed
range is –3 to +3 times normal speed.
To carry out playback in jog mode, proceed as follows.
1
Press the shuttle/jog dial to light the JOG indicator.
The shuttle/jog dial enters jog mode.
2
Press the SHUTTLE/JOG button or VAR/JOG button,
turning it on.
3
Turn the shuttle/jog dial in the desired direction, at the
speed corresponding to the desired playback speed.
Playback in jog mode starts.
4
To stop playback in jog mode, stop turning the shuttle/
jog dial.
When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to “dial” (factory
default setting), you can start jog playback by simply
rotating the shuttle/jog dial, even when the
SHUTTLE/JOG and VAR/JOG buttons are not lit.
Playback in shuttle mode
In shuttle mode, you can control the speed of playback by
the angular position of the shuttle/jog dial. The range of
playback speed is ±20 times normal speed.
To carry out playback in shuttle mode, proceed as follows.
1
Press the shuttle/jog dial to turn off the JOG indicator.
The shuttle/jog dial enters shuttle mode.
2
Press the SHUTTLE/JOG button, turning it on.
3
Turn the shuttle/jog dial to the desired angle
corresponding to the desired playback speed.
Playback in shuttle mode starts.
4
To stop playback in shuttle mode, return the shuttle/
jog dial to the center position, or press the STOP
button.
When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to “dial” (factory
default setting), you can start shuttle playback by
simply rotating the shuttle/jog dial, even when the
SHUTTLE/JOG button is not lit.
To alternate between normal-speed playback and
shuttle mode playback
Set the shuttle/jog dial to the position corresponding to the
desired shuttle playback speed, then switch between
normal-speed playback and shuttle playback by pressing
the PLAY and SHUTTLE/JOG buttons alternately.
JOG indicator: Lit
JOG indicator: Unlit