Sony XDCAM PDW-HR1, Operation Manual, Page: 118 / 214

118
Editing Operations
Cha
p
te
r 6
E
d
it
L
ist
E
d
itin
g
If you did not load an edit list in step
2
, use the Save
Clip List as… command in the Edit Menu to save the
edit list
(see page 95) .
When two edit points or less have been set, the editing
screen changes into full-screen playback of a section
until the edit section is confirmed, including the preroll
and postroll sections.
The preroll and postroll sections are not played when
PLAYER SEL in the Edit Menu is set to “external”.
If you started an open-end edit
If you started an open-end edit (by setting the material
and edit list In points only), then view the playback on
the video monitor, watching for a frame to use as the
end of the material. When the frame appears, press the
ENTRY button while holding down the OUT button,
or press the STOP button.
11
To add more material, repeat steps 3 to 10 .
To review editing results
To review the editing results after an auto edit, press the
PREVIEW button while holding the SHIFT button down.
The editing screen changes to a full-screen viewer, which
plays the edit section, including the preroll and postroll
sections.
Review execution range
The following figure shows the review execution range for
an example in which In and Out points were set in material
C0225, and then material C0225 was inserted into sub clip
C0002.
Recording range when PLAYER SEL is set
to “external”
The range from 2 seconds before the In point to 2 seconds
after the Out point is recorded to the disc.
The editing operation does not end if a timecode break
exists in the range described above.
To adjust the In and Out points of sub clips
(trim)
1
In the EDIT LIST screen, select a sub clip.
2
Press the RECALL button.
The Clip List (Trim) screen appears.
To display a list of In and Out point operations that
you can perform
Press the MENU button.
3
When you find the point that you want to make the
start point, select “IN” and then press the PUSH SET
knob.
The timecode of the new In point appears in the
timecode display, and the Total (total duration) and
DUR (clip duration) displays are updated.
4
When you find the point that you want to make the end
point, select “OUT” and then press the PUSH SET
knob.
The timecode of the new Out point appears in the
timecode display, and the Total (total duration) and
DUR (clip duration) displays are updated.
To cue up the In point or Out point
Display the Edit Menu, select Cue up Inpoint or Cue
up Outpoint, and then press the PUSH SET knob.
To cancel the In point or Out point setting
Display the Edit Menu, select Reset Inpoint or Reset
Outpoint, and then press the PUSH SET knob.
The In point or Out point setting returns to the previous
value.
5
Press the AUTO EDIT button.
The original sub clip is replaced with the range
specified in steps
3 and 4 , and the updated edit list is
saved automatically.
If an edit list has not been loaded, use the Save Clip
List as... command in the Edit Menu to save the edit
list
(see page 95) .
6
Repeat steps
1
to
5
as required.
Note
Note
1
Review execution range
2
Preroll time: 3 seconds
3
Postroll time: 2 seconds