7
Location and Function
of Parts and Operation
Front/Top/Bottom
a
Lens mount (C-mount)
Attach any C-mount lens or other optical equipment.
Note
Use a C-mount lens with a protrusion (a) extending from
the lens mount face (b) of 10 mm or less.
When you use the camera with the lens attached, the
resolution of the image output from the camera may
differ according to the performance of the lens. Note it
when you select a lens.
The performance of a lens may change according to the
aperture level.
If the resolution is not enough, adjust the aperture level.
b
Guide screw holes (Top)
c
LED light guide screw hole (Front)
Screw hole to guide LED light.
Prepare appropriate adopter according to the LED light
to guide.
d
Guide screw holes / Tripod screw holes (Bottom)
When using a tripod, use these four screw holes to attach
a VCT-333I tripod adaptor.
e
Reference screw holes (Bottom)
These precision screw holes are for locking the camera
module. Locking the camera module into these holes
secures the optical axis alignment.
Note
Refer to the outer dimensions on page 54 about the
guide hole and the position and size of standard hole.
Using a tripod
To use the tripod, install the tripod adaptor VCT-333I
(not supplied) on the camera module.
Use a tripod screw with a protrusion (
4
) extending from
the installation surface, as follows, and tighten it, using
a screwdriver. Be sure that the protrusion (
4
) does not
exceed 5.5 mm (0.22 in.) in length.
Length 4.5 to 5.5 mm
Length 0.18 to 0.22 inches
Note
If you install a tripod adapter (not supplied), use the
screws provided.
a
b
