21
Camera Control Commands
Manual B Gain Setting
One-Push AWB Execution
ATW Entrainment Speed Setting
CRS Setting during ATW
PIC (Picture)
Aperture Compensation Mode Setting
Detail Enhancer Setting
2D-NR Setting
Command
Name
BGAIN
Parameter 1
B gain: 0 to 4095
0: Minimum to
4095: Maximum
Default B gain is 3200K
Conditions
Valid when WB-MODE is 2.
Process
Sets the B gain when WB Mode is
“2: Manual.”
Command
Name
AUTOWB
Parameter
None
Conditions
Valid when WB-MODE is 0.
Process
Starts One-Push AWB processing.
When processing is finished, one of the
following is returned:
AWB OK: Normal finish
AWB TIMEOUT: Time-out failure
AWB ERROR: Other failure
Command
Name
ATW-SPEED
Parameter 1
Entrainment speed: 0 to 2
0: Slow
1: Normal
2: Fast
Default is 1
Conditions
Valid when WB-MODE is 1.
Process
Sets the entrainment speed for ATW/CRS.
Command
Name
CRS-MODE
Parameter 1
CRS Mode, 0 to 1
0: OFF
1: ON
Default is 0
Conditions
Valid when WB-MODE is 1.
Process
Enables or disables the CRS function.
Command
Name
DTL-MODE
Parameter 1
Aperture Compensation Mode: 0 to 4
0: Off
1: Vertical aperture compensation
2: Horizontal aperture compensation
3: Ve horizontal aperture
compensation
4: Highlight aperture compensation
Default is 2
Conditions
None
Process
Sets the aperture compensation mode.
Increases sharpness by emphasizing image
contours.
Command
Name
DTL-ENHANCER
Parameter 1
Detail enhancer enable/disable setting: 0 to 1
0: OFF
1: ON
Default is 0
Conditions
None
Process
Enhances signal details that may be
obscured by normal contour emphasis
(aperture compensation) processing.
Command
Name
2DNR-MODE
Parameter 1
Filter selection: 0 to 3
0: 2D-NR disabled
1: Mild 2D-NR
2: Moderate 2D-NR
3: Strong 2D-NR
Default is 1
Conditions
None
Process
Sets the strength of 2D-NR noise
suppression. Higher noise suppression
corresponds to lower resolution.
The 2D-NR function performs spatial filtering
on an image to suppress noise effects within
a specific range.
