28
GB
Check your car’s auxiliary power connector and
match the connections of cords correctly
depending on the car.
Common connection
When the positions of the red and yellow
leads are inverted
For cars without ACC position
After matching the connections and switching
power supply leads correctly, connect the unit to
the car’s power supply. If you have any questions
and problems connecting your unit that are not
covered in this manual, consult the car dealer.
To capture your voice during handsfree calling, you
need to install the microphone
.
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Note
Before attaching the double-sided tape
, clean the
surface of the dashboard with a dry cloth.
1
To enable the wired remote control, set
[Steering Control] in [General] to [Preset]
(page 16).
Installation of the rear view camera (not supplied) is
required before use.
The picture from a rear view camera connected to
the CAMERA IN terminal is displayed when:
the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
you press HOME, then touch [Rear Camera].
Power connection diagram
12
continuous power
supply
Yellow
15
switched power supply
Red
12
switched power supply Yellow
15
continuous power
supply
Red
Auxiliary power connector
Red
Red
Yellow
Yellow
Red
Red
Yellow
Yellow
Red
Red
Yellow
Yellow
Installing the microphone
Using the wired remote control
Using the rear view camera
Clip (not supplied)