Sony VPL-PX21, Operating Instructions Manual

Page: 33 / 124

33
(GB)
6
Close the lamp cover and tighten the screw.
7
Turn the projector back over.
8
Connect the power cord and turn the projector to
the standby mode.
9
Press the following keys on the control panel in
the following order for less than in five seconds
each: RESET,
<
,
,
, ENTER.
Notes
• Be sure to use the LMP-P201 Projector Lamp for
replacement. If you use lamps other than LMP-P201,
the projector may cause a malfunction.
• Be sure to turn off the projector and unplug the
power cord before replacing the lamp.
• Do not put your hands into the lamp replacement
spot, or not fall any liquid or object into it to avoid
electrical shock or fire.
Disposal of used projector lamp
As the materials used in this lamp are similar to those
of a fluorescent lamp, you should dispose of a used
projector lamp in the same way as a fluorescent lamp.
Cleaning the Air Filter
The air filter should be cleaned every 300 hours.
When it becomes difficult to remove the dust from the
filter, replace the filter with a new one.
To clean the air filter, follow the steps below:
1
Turn off the power and unplug the power cord.
2
Remove the air filter cover while holding down
the air filter cover button on the filter cover.
3
Peel off the air filter. (The air filter is secured
with Velcro tape (3).)
4
Remove the dust from the filter with a vacuum
cleaner.
5
Install the air filter as shown in the figure. Install
the air filter cover on the projector.
Notes
• Just placing the air filter on the Velcro tapes will not
lock the air filter in place. When installing the air
filter, place it on the air filter cover and attach by
pressing down hard on the three Velcro tapes. Make
sure that the air filter is not bent.
• Set the air filter correctly (straight) in the air filter
cover. If the air filter is not straight, the filter may
malfunction.
• If the air filter is excessively dirty, wash it with a
mild detergent solution and dry it in a shaded place.
If the dust cannot be removed, replace the air filter
with the supplied new one.
• The air filter has front and back sides. Make sure
you install the air filter in the right direction. Check
the notch on the filter as shown in the figure above
and install properly.
• Be sure to attach the air filter cover firmly; the power
will not be turned on if it is not closed securely.
Maintenance
Notch
Maintenance