27
Setup Menu
The Setup menu is used to change the factory preset settings, etc.
Setting items
Description
Status
Sets whether or not on-screen messages or menus, etc. are displayed.
On:
Displays on-screen messages and menus.
Off:
Turns off the on-screen displays, other than certain menus, a message when turning off the power,
and warning messages.
All Off:
Turns off the on-screen displays, other than certain menus, and a message when turning off the
power.
• When “All Off” is selected, warning message for high temperature is not displayed.
• Note that Sony is not liable for failure of the unit or any accident caused by selecting “All Off.”
Language
Selects the language used in the menu and on-screen displays.
Menu Position
You can change the position to display the menu on the projection surface.
Bottom Left:
Displays the menu on the bottom left area of the projection surface.
Center:
Displays the menu on the center of the projection surface.
Constant Brightness
On:
The light output decreases and enables constant brightness for a long period.
Off:
Turns off the Constant Brightness function.
Tip
If you use the unit with this item set to “On” for a long time, the fan speed may increase to maintain the
product reliability of its components and the fan noise may become louder.
Periodic LD Calibration
Performs the calibration automatically after a certain period of use. At that time, the calibration starts
when the
?
/
1
button of the unit or the
1
button of the remote controller is pressed, and after the
calibration finishes the power turns off.
On:
Performs the calibration automatically.
Off:
Does not perform the calibration automatically.
High Altitude Mode
Sets the unit to operate at the prevailing atmospheric pressure.
On:
Use this setting when using the unit at an altitude of 1,500 m (approx. 4,900 ft) or higher.
Off:
Use this setting when using the unit at normal altitudes.
Tip
When this item is set to “On,” the fan noise becomes slightly louder since the fan speed increases.
Remote Start
Sets the Remote Start settings.
On:
You can turn on the power from a PC or a terminal which is connected to a network.
Off:
Turns off the Remote Start function.
Tips
• To use the function, the unit should be connected to the network in advance (page 33).
• To turn on the power with the Remote Start function, a special command should be sent from a PC or
a terminal. For details, consult with qualified Sony personnel.
When the Remote Start is set to “On,” the standby power requirement will increase. When Network
Management is set to “On,” Remote Start is fixed at “On” and is not displayed in the menu.
Notes
Note
Summary of Contents for VPL-GTZ270
Page 54: ...Sony Corporation ...
