34
The Connection/Power Menu
The Connection/Power menu is used for setting for the connections and power.
Setting items
Description
Network Setting
IPv4 Setting
*1
IP Address Setup
Auto(DHCP):
The IP address is assigned automatically from the
DHCP server such as a router.
Manual:
To specify the IP Address manually.
IP Address/ Subnet
Mask/ Default
Gateway/Primary
DNS/Secondary
DNS
When “Manual” is selected for “IP Address Setup,” select the item
with the
B
or
b
key and input the value with
V
or
v
key. When all
items are entered, select “Apply” then press the ENTER key. The
entered settings will be registered.
IPv6 Information
Displays the IPv6 address information.
When setting the address of IPv6, set it from the browser (page 45).
HDBaseT Settings
LAN Setting
via HDBaseT/LAN Port:
You can select either via the LAN of the
HDBaseT equipment connected to the HDBaseT teminal or via the
network connection with the LAN terminal of the main unit.
*2
RS-232C Setting
*3
via HDBaseT:
You can connect this unit to the RS-232C terminal via
the HDBaseT transmitter. (Baud rate: 9,600 bps)
RS-232C:
Use when connecting to the RS-232C terminal of this unit
directly.
Extron XTP
On/Off:
Set to “On” when connecting the HDBaseT terminal of this
unit to XTP Systems
*4
manufactured by Extron Electronics. Set to
“Off” when connecting to other equipment.
Dynamic Range
*5
Sets the image input level of the INPUT B/C/D terminal.
Auto:
Distinguishes the image input level automatically.
Limited:
Set when the image input level is 16-235.
Full:
Set when the image input level is 0-255.
HDMI Cable
Long/Normal:
Select “Long” when the image is disturbed or not
projected.
Input-A Signal Sel.
Auto/Computer/Video GBR/Component:
When set to “Auto,”
selects the type of video signal input automatically when “Input-A” is
selected with the INPUT key.
*6
Color System
Auto/NTSC
3.58
/PAL/SECAM/NTSC
4.43
/PAL-M/PAL-N:
When set
to “Auto,” selects the color system automatically when “Video” is
selected with the INPUT key.
*6
ECO
Auto Power Saving
With No Input
Light Cutoff:
The light turns off automatically and power
consumption is reduced if no signal is input for about two minutes.
The light turns on again when a signal is input or any key is pressed. In
Light Cutoff, the ON/STANDBY indicator lights in orange. (page 49)
Standby
*7
:
If no signal is input to the unit for about two minutes, the
power turns off automatically, and the unit enters standby mode.
Off:
The “With No Input” function is disabled.
