Sony VPL CX125 - XGA LCD Projector, Operating Instructions Manual

Page: 26 / 69

26
Projecting
To operate with the Control Panel
or the Remote Commander of
VPL-CX100/CX120/CX150
Each time you press the INPUT key, the
input signal switches as follows:
• If “Auto Input Search” is set to “On,” the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
• When the no signal is input to the VPL-
CX125/CX155, “Input-C” is selected.
For details, see “Auto Input Search” in
the Function Menu on page 38.
5
Switch the equipment connected to
output to the projector.
Depending on the type of your
computer, for example a notebook, or an
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys (e.g.,
, etc.), or by
changing your computer’s settings.
The key used for switching the computer to
output to the projector varies depending on
the type of computer.
6
Adjust the upper or lower position of
the picture.
Use the adjuster to adjust the picture
position.
Using the adjuster
1
Lift the projector while pressing the
Adjuster adjustment button.
2
Adjust the tilt of the projector.
3
Release the Adjuster adjustment
button.
4
When fine-tuning is necessary, turn
the Adjuster right and left.
• When you adjust the tilt of the projector
with the adjuster, the V keystone
adjustment is performed at the same
time. If you do not want to perform the
To input from Press INPUT
to display
Computer, Component,
Video GBR etc.
connected to the
INPUT A connector Input-A
Computer, etc.
connected to the
INPUT B connector Input-B
Computer connected to
LAN to use the network
presentation function Input-C
(VPL-
CX125/
CX155 only)
Video equipment
connected to the VIDEO
input connector Video
Video equipment
connected to the
S VIDEO input
connector S-Video
Notes
* VPL-CX125/CX155 only
Note
Notes
or
and
NET
WOR
K
INPU
T C
RGB
AUD
IO
INPU
T A
MON
ITOR
AUD
IO
OUTP
UT
S VID
EO
AUD
IO
RS-2
32C REM
OTE
VIDE
O VIDE
O IN
RGB
INPU
T B
13
2
4