Sony VPH-G90E, Installation Manual

Page: 38 / 480

38
(GB) Connections
Connections
When you install the optional IFB-40 Signal Interface Board to the
projector and connect the PC-1271/1271M Signal Interface Switcher to the
IFB-40, you can connect easily various input sources.
You can select the input to the switcher easily by pressing the
SWITCHER/VIDEO MEMORY/INDEX keys on the remote commander.
Connecting the PC-1271/1271M using the SIC-M or CCQ-BRS connecting cable
Choose the appropriate cable from the following table.
1 m 2 m 5 m 10 m 15 m 25 m 50 m
— CCQ-2BRS CCQ-5BRS CCQ-10BRS — CCQ-25BRS CCQ-50BRS
SIC-M-1 — SIC-M-5 — SIC-M-15 SIC-M-25 SIC-M-50
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable
correctly.
• You can extend the SIC-M or CCQ-BRS cable up to 50 m.
• The video signal input to the IFB-40 installed to the INPUT B section
should not exceed 70 MHz. When projecting the video signal which
exceeds 70 MHz, connect the signal source to the INPUT A connectors
using the 5BNC cables.
Setting up
• Set INPUT-A in the SET SETTING 1 menu
(on page 62
(GB)
)
to RGB.
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote commander.
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
TRIGGER LINK
S VIDEO
OUT IN
C IN Y IN
VIDEO
VIDEO
R-Y/P R
R
B-Y/P B
G B SYNC/HD VD
INPUT A
Y
CONTROL S
PLUG IN POWER
DEVICE INDEX
IN OUT
IN OUT
IN OUT
REMOTE
RS-232C/422A
RS-232C RS-422A
IN OUT PJ COM
IN OUT
MODE REMOTE1
Using the PC-1271/1271M Signal Interface Switcher
to REMOTE 1 OUT
SIC-M or CCQ-BRS
connecting cable
Rear
PC-1271/1271M
Switcher
Video
equipment
Video
equipment
Computer
AC power cord (supplied)
to a wall outlet
R G
B
SYNC/HD
VD
to RGB output to video output
to S Video output
VIDEO IN
IFB-40 Signal
Interface Board
(optional)
IN
S VIDEO
IN
AC IN
Signal flow
INPUT A
*
For the VPH-G90E model: IFB-G90E Video Interface Board (optional)
*