Sony VPH-G70Q, Installation Manual

Page: 74 / 362

74
(EN) Adjustments
Adjusting the Registration
Adjustments
I N
I N T . O S C P A T T E R P 0
I N T . O S C M O D E : O P 1
D I R E C T P O W E R O P 2
R S - 4 2 2 A : 3 8 . 4 K
f H = 3 1 . 5 K H z
f V = 6 0 H z
SERVICE
SETTING
SET
INFO.
UNI
FORMITY
ABL
LINK
SEL: SET: ENTER EXIT: MENU
S
Preparation
1
Mark the center of the screen.
Measure the height and width of the screen to determine the center.
Marking five points with white tape, as illustrated below, will help you
adjust registration.
2
Set the remote control to the service adjustment mode.
For details, see “For Remote Control” on page 38 (EN).
3
Press one of the INPUT SELECT keys corresponding to a line that is
not connected to a signal so that “NO INPUT” appears.
Or, set the SWITCHER/INDEX select switch to SWITCHER and then
press the number key from
1
to
8
, corresponding to a line that is not
connected to a signal.
4
Display the SERVICE SETTING menu, select INT. OSC PATTERN,
then select the frequency to be used for the adjustment.
For details, see “The SERVICE SETTING Menu” on page 55 (EN).
5
Reset the standard data to the factory preset level.
(Only when you have adjusted the registration and have saved the
adjustment data.)
For details, see “Resetting the Data” on page 107 (EN).
Notes
• The center of the screen and the center of the CROSS HAIR pattern can be
aligned by performing the centering adjustment.
For details, see “Green CENT (centering) adjustment” on page 76 (EN).
• When the optical axis angle is smaller, the HATCH pattern becomes trapezoidal.
Perform the KEY (keystone) adjustment to correct the distortion.
For details, see “Green KEY and PIN adjustments” on page 81 (EN).
1 2 3
5
4
I N P U T - A N O I N P U T