48
Attachment and Installation Procedures
To remove the shoe mount adapter
Installing a diversity tuner
module (URX-M2)
• Before installing the diversity tuner
module (URX-M2), make sure the unit
into which the tuner module will be
installed is turned off. Do not install or
uninstall the tuner module while the unit
into which the tuner module will be
installed is turned on, as this may result in
malfunction of the tuner module or cause
noise.
• Do not put your fingers on the connectors
on the rear panel of the tuner module or
into the slot on the unit into which the
tuner module will be installed.
• Keep the tuner module away from static
electricity.
To install a diversity tuner
module (URX-M2) into the
optional MB-X6 Tuner Base
Unit
The MB-X6 Tuner Base Unit (not supplied)
can accommodate up to 6 diversity tuner
modules (URX-M2).
For details on installation procedure, refer to the
Operating Instructions supplied with the MB-X6.
Hold the tuner module by the side and insert
it into the slot until you hear a click.
To install two or more tuner
modules
Before installing the tuner modules, detach
the necessary number of blank panels from
the front cover of the MB-X6.
To uninstall a tuner module
After removing the front cover of the MB-
X6, hold the tuner unit by the top and
bottom, then pull it out of the slot.
Notes
While pushing on the “PUSH” marking
on the shoe mount adapter (
1
),
disengage the horizontal part of the belt
clip from the horizontal groove on the
shoe mount adapter (
2
). Then, push
the shoe mount adapter in the direction
of the arrow (
3
).
Summary of Contents for UWP-V1
Page 71: ......
