![Sony UHC-8300 Operating Instructions Manual Download Page 8](http://html.mh-extra.com/html/sony/uhc-8300/uhc-8300_operating-instructions-manual_418358008.webp)
8
m
CRANE connector (12-pin)
For external interface, such as viewfinder and external data.
n
MAG CTRL (MAG control) connector (14-pin)
Attach devices, such as a MAG controller.
For detailed information about this connector, contact a Sony
service representative or Sony sales representative.
o
NETWORK TRUNK connector (RJ-45 8-pin)
Connects a device connected to the CCU’s NETWORK
TRUNK connector to the network.
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to the
following port:
NETWORK TRUNK connector
• When you connect the following cable(s) of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
– Network cable
Preparations
Attaching a Lens
For information on handling lenses, refer to the lens’ operation
manual.
Attaching a 1.25 inch lens
1
Turn the lens mount cap counterclockwise to remove
it.
2
Align the lens alignment pin with the notch on the
lens mount, then insert the lens straight all of the way.
3
To secure the lens, support it while turning the lens
ring clockwise.
4
Connect the lens cable to the camera connector.
Note
CAUTION