– 9 –
KV-AR14M50/AR14M80/AR14P52
RM-W101
Note:
• Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom
right and left.
1) Place the TV set with the CRT face down on a cushion jig.
2) Remove the rear cover.
3) Unplug all inter connecting leads from the Deflection Yoke, Degaussing Coil and CRT grounding strap.
1-7.
PICTURE TUBE REMOVAL
4
Anode Cap Removal
5
C Board Removal
7
Chassis Assy Removal
qa
Spring Tension Removal
qd
Nut, Special, CRT (x4)
0
Degaussing Coil
6
Loosen the Deflection Yoke
fixing
screw
and
remove
8
Support, CRT Removal (x2)
qs
Earth Coating Assy
qf
Top switch, block
• REMOVAL OF ANODE-CAP
Note:
• After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT
shield or carbon paint on the CRT.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the direction
indicated by the arrow
A
.
2
Using a thumb pull up the rubber cap firmly in the di-
rection indicated by the arrow
B
.
3
When one side of the rubber cap is separated from
the anode button, the anode-cap can be removed by
turning up the rubber cap and pulling it up in the
direction of the arrow
C
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-caps with
sharp shaped objects.
2
Do not press the rubber too hard so as not to
damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is
built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage
the rubber.
a
a
b
b
c
Anode Button
Summary of Contents for TRINITRON KV-AR14M50
Page 1: ......
Page 51: ... 56 KV AR14M50 AR14M80 AR14P52 RM W101 IC L7805CV ...