4-8-8.
CN-3421 Board
Preparation
1.
Remove the outside panel assembly. (Refer to
“4-3-1. Outside Panel Assembly”
Procedure
1.
Remove the gasket.
2.
Remove the two screws and pull out the CN-3421 board.
3.
Disconnect the harness from the connector (CN3) on the CN-3421 board.
Harness
Ferrite core
Gasket
CN-3421 board
CN3
B2.6 x 5
Note
When installing the CN-3421 board, put the ferrite core in the figure.
4.
Install the removed parts by reversing the steps of removal.
4-8-9.
SW-1528 Board
Preparation
1.
Remove the inside panel assembly. (Refer to
.)
Procedure
1.
Remove the five toggle SW cushions.
2.
Remove the screw and pull out the SW-1528 board in the direction of arrow.
HDC4300
4-37
