4-6.
OHB Block
4-6-1.
OHB Assembly
Preparation
1.
Remove the inside panel assembly. (Refer to
2.
Remove the outside panel assembly. (Refer to
“4-3-1. Outside Panel Assembly”
3.
Remove the front assembly. (Refer to
)
Procedure
1.
Disconnect the harness from the connector (CN3) on the IF-1278 board.
2.
Loosen the two screws, and remove the FD assembly from the OHB assembly.
OHB assembly
CN3
IF-1278 board
FD assembly
Harness
Attached screws
(Tightening torque: 0.53 N•m)
3.
Remove the four screws and four washers, and detach the front panel assembly.
M3 x 8
(Tightening torque: 1.1 N•m)
SW3
Front panel assembly
OHB assembly
4.
Install the removed parts by reversing the steps of removal.
HDC4300
4-19
