watch movies at a low volume late at night, etc.
Note
Only Dolby TrueHD sources currently have the additional information that recommends using this
function.
[180] Adjusting Settings
Audio Settings
Switching the mode of the DTS decoder (Neural:X)
You can switch the DTS decoder to “Direct Mode” (Neural:X Off) or “Non-Direct Mode”
(Neural:X On).
When in “Direct Mode” (Neural:X Off), the audio is extracted and reproduced as closely as
possible to what the content creator intended. When in “Non-Direct Mode” (Neural:X On), the
audio is extracted and adapted to fit as closely as possible to the speaker layout of the playback
system (regardless of the source configuration). This function only works when the DTS stream
is input.
Note
You cannot set this function to [Off] when [Neural:X] is selected as a sound field.
You cannot set this function to [On] in the following cases:
[2ch Stereo], [Direct], [Dolby Surround] or [Front Surround] is selected.
[Pure Direct] is set to [On].
Select [Setup] - [Audio Settings] from the home menu.
1
Select [Dynamic Range Compressor].
2
Select the setting you want.
Auto:
The dynamic range is compressed automatically when there is the additional
information in the sound source that recommends using the Dynamic Range
Compressor function.
On:
The dynamic range is compressed as intended by the recording engineer.
Off
3
Select [Setup] - [Audio Settings] from the home menu.
1
Select [Neural:X].
2
Select the setting you want.
On:
The DTS decoder is switched to “Non-Direct Mode.”
Off:
The DTS decoder is switched to “Direct Mode.”
3
