Sony STR-ZA1100ES, Help Manual

Page: 219 / 333

Help Guide
MULTI CHANNEL AV RECEIVER
STR-ZA3100ES/STR-ZA2100ES/STR-ZA1100ES
Switching the mode of the DTS decoder (Neural:X)
You can switch the DTS decoder to “Direct Mode” or “Non-Direct Mode.”
When in “Direct Mode,” the audio is extracted and reproduced as closely as possible to what the content creator
intended. When in “Non-Direct Mode,” the audio is extracted and adapted to fit as closely as possible to the speaker
layout of the playback system (regardless of the source configuration). This function only works when the DTS stream is
input.
Note
You cannot set this function to [Off] when [Neural:X] is selected.
You cannot set this function to [On] in the following cases:
[2ch Stereo], [Direct] or [Dolby Surround] is selected.
[Pure Direct] is set to [On].
4-686-529-11(5) Copyright 2017 Sony Corporation
Select [Setup] - [Audio Setup] from the home menu.
1
Select [Neural:X].
2
Select the setting you want.
On: The DTS decoder is switched to “Non-Direct Mode.”
Off: The DTS decoder is switched to “Direct Mode.”
3
219