30
US
Insert two R6 (size-AA) batteries in the
RM-AAU021 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 96).
• When the remote no longer operates the receiver,
replace all the batteries with new ones.
7: Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
Press SPEAKERS repeatedly to
select the front speaker system
you want to drive.
* To select “SP B”, set “SB ASGN” to “SPK B” in
the System settings menu (page 43).
To turn off the speaker output, press
SPEAKERS repeatedly until the “SP A” and
“SP B” indicators on the display light off.
Note
You cannot switch the front speaker system by
pressing SPEAKERS when the headphones are
connected to the receiver.
Inserting batteries into the
remote
To select
Light up
The front speakers connected to the
SPEAKERS FRONT A terminals
SP A
The front speakers connected to the
SPEAKERS SURROUND BACK/
BI-AMP/FRONT B terminals
SP B*
The front speakers connected to both
the SPEAKERS FRONT A terminals
and SPEAKERS SURROUND
BACK/BI-AMP/FRONT B terminals
(parallel connection)
SP A and
SP B*
?/1
PHONES
SPEAKERS
INPUT SELECTOR
INPUT MODE
TUNING MODE
MASTER VOLUME
TONE MODE
DISPLAY
DIMMER
MUTING
MEMORY/
ENTER
2CH/
A.DIRECT
A.F.D.
MOVIE
MUSIC
TUNING
TONE
VIDEO 2 IN
VIDEO
L AUDIO R
AUTO CAL MIC
SPEAKERS
